Acudor’s RHG Galvanized Equipment Access Roof Hatches are watertight and are designed to provide convenient, economical access to the roof of a building. These equipment and roof hatches are designed with safety, durability, and ease of operation.

RHG Galvanized Equipment Access Roof Hatches Features

• Stainless Steel Hardware is standard on all hatches
• 1″ Polyiso (R-6) insulation standard on all hatches
• EPDM foam weather/draft seal gaskets provide weather-tight construction
• Supports 40lbs./sq. ft. live load

RHG Galvanized Equipment Access Roof Hatches Specifications

• Cover: Double-skin construction(“inbox type design”) with 1″ Polyiso (R-6) insulation and a continuous EPDM foam weather/draft seal gasket that is attached to the inside of the cover to provide a flush tight fit. Designed to support a live load of 40 pounds/sq. The cover is 14 gauge galvanized steel with a 22 gauge galvanized steel inside liner.
• Curb: 14 gauge galvanized steel with 1″ Polyiso (R-6) insulation thick fiberboard roof insulation at curb exterior. The curb is 12″ high, with a 3.375″ wide bottom flange and pre-drilled mounting holes.
• Hinge: Heavy-duty galvanized steel pintle hinges with 3/8″ pin
• Opening: Gas spring operators allow the cover to open and close easily. The inside pull handle allows for easy control when closing the cover
• Door Latch: self-latching, zinc plated outside T handle with stainless steel inside lock and lever assembly. The unit also has inside and outside padlock provisions
• Finish: Material is prepared with an iron phosphate wash, followed by a rust-inhibiting primer and then a baked-on polyester enamel paint

RHG Galvanized Equipment Access Roof Hatches Options

• Stainless Steel cover, curb, and/or hardware (RHG)
• Polycarbonate domes for daylighting
• Louvered Curbs
• Curb Mounted Units
• Curb pitch corrected for sloped roof
• Higher curb heights for “green roof” applications

*Custom sizes available upon request